Saskatoon Scissor Lift Certification

Saskatoon Scissor Lift Certification - Scissor lift platforms are made use of at work places to allow tradespeople - such as masons, iron workers and welders - to reach their work. Using a scissor lift platform is normally secondary to their trade. Hence, it is essential that all operators of these platforms be well trained and certified. Industry, lift manufacturers and regulators all work together to be able to ensure that operators are trained in the safe use of work platforms.

Work platforms are likewise called manlifts or AWPs. These machines are stable and simple to use, even though there is always some risk because they lift people to heights. The following are several important safety issues common to AWPs:

In order to protect those working around work platforms from accidental discharge of power because of close working proximities to wires and power lines, there is a minimum safe approach distance (also referred to as MSAD). Voltage can arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

Caution should be taken when lowering a work platform to ensure steadiness. The boom must be retracted, moving the load toward the turntable. This will help maintain stability when the -platform is lowered.

The rules about tie offs do not mandate people working on a scissor lift to tie themselves off. Several organizations would on the other hand, need their employees to tie off in their employer guidelines, local regulations or job-specific risk assessment. The anchorage provided by the manufacturer is the only safe anchorage to which lanyard and harness combinations should be attached.

Observe the maximum slope rating and do not exceed it. A grade could be measured by laying a board or straight edge on the slope. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, you can determine the percent slope.

A regular walk-around inspection has to be carried out to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is essential specially on changing construction sites due to the chance of obstacles, unimproved surfaces, and contact with power lines. A function test has to be performed. If the unit is used properly and safely and proper shutdown procedures are followed, the risks of accidents are really reduced.

Click to Download the pdf